I put the 3D printer through its paces a bit today. I found a file of the Thundercats logo and decided to print it out. It was very large and I did not add glue to the hotbed prior to printing so partway through the build it separated from the hotbed and did not come out as clean as it could have.
It is fun watching these being printed. Interesting to see how each layer is made. The large print was 85 layers and took a little over 2 hours to print. I reduced the size to a 9mm diameter ad that made the print 73 layers and took about 46 minutes to print. The second time I put down some glue from a glue stick and it did not separate from the hotbed as it printed. The second print is so much smoother and precise.
You can see on the outer rim of the build that it looks scruffy. That was because the bottom separated from the hotbed and I wasn’t sure if I should scrap the build or let it play out. I let it play out. I can use that one as a test for painting.