This is the Sword of Omens fully printed and I even found craft dowels to add to it to strengthen it. I still have a lot of work to do to actually assemble it. I do have to reprint part of the handle because the first time I printed it the bottom curled up and peeled away from the hotbed. I ended up adding some supports to it so that it would print flat. I also will have to do a lot of sanding and also add some filler to it before it can be printed. I also noticed that one piece does not quite fit into another and I’ll need to sand that down as well. I’ll also have to sand the larger dowel down in order for it to fit through one smaller part of the handle. Once I have it all assembled I’ll see if the Prestons’ daughter Cady would like to paint it.